![\"\"](\"https:\/\/pinball.teta.be\/wp-content\/uploads\/2011\/11\/DSCF0033.jpg\" "\\"DSCF0033\\"")
<\/a>New fuse clips installed<\/p><\/div>\n
Then I took out the sunken inserts.<\/p>\n
<\/a>All sunken inserts removed<\/p><\/div>\n
After a close inspection I saw that the 3000 hole is in the worst shape. It will need some wood filler and paint touch up.<\/p>\n
<\/a>This one is in the worst shape<\/p><\/div>\n
I’ve reseated the inserts with some superglue, they shouldn’t move anymore.<\/p>\n
<\/a>Inserts reseated, still need to fill the wood and touch up the paint<\/p><\/div>\n
I also took apart all the targets at the end of the playfield, cleaned them and reinstalled them. Fortunately, the print on them is still in good condition, so I don’t have to replace any of them.<\/p>\n
<\/a>Targets cleaned and adjusted<\/p><\/div>\n
With that done, I started on the popbumpers. They were dirty and one is using a wrong coil that didn’t fit very well and was missing some screws.<\/p>\n
<\/a>Rebuilding the popbumper coil assembly<\/p><\/div>\n
<\/a>Rebuilding the popbumper<\/p><\/div>\n
All the popbumpers are now clean and ready to be reinstalled. I kept the one with the wrong coil as I’m still looking for a replacement coil.<\/p>\n
I also took apart the outhole kicker, cleaned it and reinstalled it. I noticed that the wrong coil used in the popbumper is the same coil that is used for the outhole kicker. So if I ever find a new popbumper coil, I’ll have a spare outhole kicker coil.<\/p>\n